K1/K1C Door Color:Smoked

K1/K1C Door Color:SmokedWe are happy to offer door options for the Creality K1 K1C printers! We are offering these doors in both Acrylic or Polycarbonate, Clear or Smoked! These replace the stock doors, and are for the panels only. You will reuse the existing hardware, and won't have to worry about glass breaking on you. Peel protective film or paper before installation. Please Note: DO NOT use any alcohol based cleaner near panels. It will cause them to crack. Stick to

instead of over them

We recommend heaters and flex plates from KB3D

No electronics to be affected by heat

The STL for increasing the height of the nozzle touch off button is here courtesy of Kris at KB3D

This gives a very superior holding power

PLEASE NOTE: These are not needed for a 1515 railcore build

Please be aware that most electronic probes will have issues with the embedded magnets and will cause high spots while probing

and Voron tap triggers with around 600g of force

or for the stock printer

Here are some basic instructions for that process:

Mandala Rose Works magbed for the E3D Toolchanger is designed to mount onto the existing mounting holes for the printer

not auto-deploy configuration